Sea buckthorn oil is rich in unsaturated fatty acids and a range of natural bioactive vitamins. Its components are highly heat-sensitive and susceptible to oxidative rancidity under the influence of oxygen, elevated temperature and impurities-a process that manifests as quality deterioration, including deepened colour, rancid off-flavours and an elevated acid value. Supercritical CO₂ extraction inherently offers the advantages of low temperature and closed operation and can preserve the active substances in sea buckthorn oil to the greatest extent. Nevertheless, an advantageous process does not by itself deliver oxidation resistance. Oxidation control must run through the entire workflow, from raw material pretreatment through extraction to separation and collection. The key control points for each stage are set out below.
1. Raw Material Pretreatment Control: Preventing Prior Oxidation
Once sea buckthorn seeds are crushed, the cellular structure of the oil-bearing material is disrupted and the oil, together with its active components, is directly exposed to air, so that the oxidation rate rises markedly. Crushing should therefore be carried out on demand; as soon as crushing is completed, the material should be charged into the extraction vessel without delay, and crushed material should not be left in open-air stockpiles for extended periods. Where temporary storage is unavoidable, the material should be kept sealed against oxygen, protected from light and held at low temperature. If the raw material has already become oxidised, no optimisation of subsequent extraction parameters can restore the baseline quality of the finished oil.
2. Charging and In-Vessel Deoxygenation: Establishing the First Oxygen Barrier
Once the material has been loaded, the extraction vessel should be sealed immediately, and prolonged exposure of the vessel to air should be avoided. After sealing, the air inside the vessel should first be purged before CO₂ is introduced to establish the extraction system, so that the oxygen content within the vessel is reduced to the lowest practicable level and the oxidation reaction is suppressed at its source. This is a key step that is easily overlooked in day-to-day production.
3. Stable Temperature and Pressure during Extraction: Reducing Degradation of Active Components
Extraction parameters should be matched to the characteristics of the sea buckthorn oil charge rather than copied from those used for other materials. The extraction temperature should be controlled within the range of 35–40 °C and maintained constant throughout the run, with fluctuations strictly limited. A higher temperature does accelerate the oxidation of unsaturated fatty acids, and frequent temperature fluctuation is even more damaging to the active substances. The extraction pressure should be maintained in the low range of 16–20 MPa. Under this low-temperature, low-pressure regime, the sea buckthorn oil is effectively extracted and the extraction yield remains stable, while the risk of degradation of heat-sensitive nutrients is reduced, balancing output against quality.
4. Closed and Temperature-Controlled Separation and Collection: Preventing Rapid Oxidation at the Oil-Discharge Stage
Separation and collection constitute a high-risk stage for oxidation and are particularly easy to overlook. The sea buckthorn oil leaving the separation vessel still carries residual heat, and when hot oil comes into contact with air its oxidation rate rises sharply. In practice, the collection tank is therefore pre-cooled and connected in a closed configuration, with the discharge process kept closed to the atmosphere throughout. The pipelines and collection vessels should be checked for tightness beforehand, and every valve joint should be leak-tested, so that air cannot be drawn back into the collection system. Provided that closed operation and temperature control are maintained during discharge, the finished oil retains a clear colour and does not darken rapidly.
In short, supercritical CO₂ provides sea buckthorn oil with a low-damage extraction environment, but oxidation resistance is a continuous chain of control measures: from the crushing and charging of the seeds, through in-vessel oxygen removal and stable temperature–pressure control during extraction, to closed low-temperature collection at the separation stage. No link in this chain can be neglected. When the entire procedure is properly implemented, the resulting oil has a transparent colour, is free from rancid off-flavours, retains its active substances to a higher degree, and shows markedly better storage stability and shelf life than batches produced under loosely controlled conditions.
